Reversing into a closed garage door happens more often than you'd think. The good news: a dented or bowed section rarely means you need a whole new door. We straighten sections, add steel strut reinforcement and brace hinges so your door runs smoothly again — at a fraction of the cost of replacement.
Common symptoms you'll see or hear
- ✔ Visible dent or crease across a panel
- ✔ Panel bowing inward or outward
- ✔ Door catches or binds at the dented section
- ✔ Hinges pulled out or cracked around the panel
- ✔ Gaps between sections where light shows through
- ✔ Door no longer seals at the floor
Why this failure happens
Sectional door panels are designed to flex as they roll over the track curve, which also makes them vulnerable to impact. A dent changes the panel's shape, stresses hinges and can push rollers out of line.
Wide double doors often sag in the middle over time, especially without enough reinforcement struts — a common issue on older Perth homes.
How our technician repairs it on-site
We assess the damage, straighten the section where possible, then fit steel strut reinforcement across the panel to restore rigidity. Damaged hinges and brackets are replaced and the door is rebalanced.
If a single section is beyond repair, we can advise on sourcing a matching section for your existing door. We do not sell complete new doors.
Frequently asked questions
Can a dented garage door be repaired?
In most cases, yes. Strut reinforcement and section straightening restore smooth operation.
Will the dent disappear completely?
Minor dents often improve significantly; deep creases may still be visible but the door will operate properly.
Is panel damage covered by insurance?
Often yes. We can provide a written quote and invoice for your insurer.
